SECTION 6—FRONT RIGGINGS
34
• Wheelchairs with Manual or Power Center Mount Front Rigging - Slide the seat
frame mounting brackets as far as possible towards the rear of the wheelchair.
Leave 1 to 1½-inch of clearance between the center mount front riggings and the
front shroud.
3. Ensure the interface mounting brackets and the seat frame mounting brackets are
flush and square.
4. Secure the seat frame mounting brackets to the interface mounting plates. Torque the
four hex bolts and locknuts to 13 ft-lbs ± 20%.
5. Cycle the tilt and/or recline functions to verify wiring harnesses DO NOT obstruct the
path of the system. If they do, perform one of the following:
• Wires were damaged during inspection - Replace damaged wires.
• Wires were not damaged during inspection - Cut tie-wraps and relocate wires to a
location where they will not become damaged.
FIGURE 6.14
Adjusting the Seating System Mounting Position
Hex Screws
Locknut
Locknuts
Interface Mounting
Bracket
Seat Frame
Mounting Bracket
ASBA Seating System
(Base Only Shown)
Rear of
Wheelchair
