7 SETUP/MAINTENANCE
Part No 1143192
75
Invacare® Adjustable ASBA Seats
7.12 Removing/Installing/Adjusting Headrest
Removing
1.
Loosen, but DO NOT remove, the thumb screw that secures the
headrest to the headrest mounting bracket.
2.
Remove the headrest from the headrest mounting bracket.
Installing
1.
Make sure thumb screw is loose.
2.
Install the headrest until the headrest stop sits on the headrest
mounting bracket.
3.
If necessary, adjust the height, depth or direction of the headrest.
Refer to Adjusting Headrest Height on page 75 or Adjusting
Headrest Depth/Direction on page 76.
Adjusting Headrest Height
1.
Loosen the set screw on the headrest stop.
2.
Loosen, but DO NOT remove, the thumb screw that secures the
headrest to the headrest mounting bracket.
3.
Position the headrest to the desired height.
4.
Tighten the thumb screw that secures the headrest to the headrest
mounting bracket.
5.
Tighten the set screw on the headrest stop.
6.
If necessary, adjust the depth or direction of the headrest. Refer to
Adjusting Headrest Depth/Direction on page 76.
FIGURE
10
Removing/Installing/Adjusting Headrest
CAUTION
If using a ventilator, verify headrest support does not interfere at all angles. Otherwise, injury or damage may occur.
Depth
Adjustment
Offset Fixture
Slide Tube
Socket
Screws
Height
Adjustment
Thumb
Screw
Headrest Mounting
Bracket
Headrest Stop
Set Screw
