5 USAGE
Invacare® Adjustable ASBA Seats
38
Part No 1143192
5.4
About Front Riggings
Installing/Removing Footrests
PH904A, PHAL4A, 70° and PW93
1.
Turn the footrest to the side (open footplate is perpendicular to
wheelchair).
2.
Install the hinge plates on the footrest onto the hinge pins on the
wheelchair frame.
3.
Push the footrest towards the inside of the wheelchair until it locks
into place.
4.
Repeat STEPS 1-3 for other footrest assembly.
5.
To remove the footrest, push the footrest release lever inward,
rotate footrest outward.
6.
Adjust footrest height, if desired. Refer to Footrest Height
Adjustment on page 51.
FIGURE
4
Installing/Removing Footrests - Ph904A, Phal4A, 70° and
pw93
WARNING
While the wheelchair is moving, minimum ground clearance for the front rigging is three inches. If the wheelchair is not
moving, the front rigging MUST maintain a minimum of one inch ground clearance - otherwise personal injury and damage
may result.
DO NOT stand on the flip-up footboard. When getting in or out of the wheelchair, make sure that the flip-up footboard is
in the upward position.
PINCH POINT EXISTS BETWEEN CENTER MOUNT FOOTREST AND CASTERS - There is limited clearance between
center mount footrest and casters. The user’s feet MUST remain on the center mount footrest while operating the
wheelchair. If the user’s feet are allowed to rest off the side of the center mount footrest they may come in contact with
the caster possibly resulting in injury.
The footplate will be on the inside of the
wheelchair when locked in place.
Footrest Release Lever
Hinge Plate
Footrest
Hinge
Pins
