SECTION 5—WHEELCHAIR OPERATION
Part No 1134791
61
3G Storm Series® Wheelchairs
• Pneumatic Control
• Stand-by Mode
• RIM Control
• Remote Drive Selection Mode
• Information Center Display Selection (does not require Reset activation at power up)
If any of the above modes are selected, the control will require activation of the switch
immediately after the power switch is turned on in order to enter the drive mode. The
second line of the LCD will display - press Reset.
Emergency Stop Reset Input Connector
The input connector accepts a 1/8-inch diameter Phono plug. The Emergency Stop switch
must be an open contact for normal driving and a closed contact to activate the
Emergency Stop function.
MKIV-RII Joystick Switches and Indicators
NOTE: For this procedure, refer to FIGURE 5.8 on page 62.
On/Off Switch
Two position toggle is located at the back of the joystick housing.
Speed Control
Rotary knob is located at the back of the joystick housing. Turning the knob clockwise
increases the maximum speed of the wheelchair.
Joystick
Proportional drive control located at the front of the joystick housing provides smooth
control of speed and direction.
Battery Discharge Indicator (BDI)
Located at the front of the joystick housing provides information on the remaining charge
in the batteries. At full charge, the BDI will be GREEN. As the battery becomes discharged,
the BDI will become YELLOW (Amber), then RED and finally the BDI will flash On and
Off Red. At this level, the user should charge the batteries as soon as possible.
The BDI will flash On and Off YELLOW to indicate a reduced speed or power output.
PIN
DESIGNATION
TIP
RESET (EMERGENCY STOP)
RING
COMMON (B–)
All manuals and user guides at all-guides.com
all-guides.com
