Intrinsyc Open-
Q™ 605 SBC User Guide and HW Specification
V. 1.4
44
Copyright Intrinsyc Technologies Corporation
If you purchased the camera module from Intrinsyc, the pin 2 location of the module will be
clearly marked at the back side of the module. See picture in below
.
Figure 22: Camera module Pin 2 location
Follow the steps below to install the camera module on to your SBC.
Warning: Make sure all power sources (DC power supply, battery, USB) are
disconnected from the SBC before installing the camera module. Failure to do so may
result in permanent damage to both the SBC and the camera module.
Step 1: With the module facing up, align the module’s connector to the camera port on the SBC
as shown below.
Figure 23: Camera module aligned to CAM0
connector
Figure 24: Camera module aligned to CAM2
connector
Step 2: Gently place the camera module’s connector on top of the SBC connector. When you feel
the guiding plastic pin on the camera connector is aligned with the SBC connector. Push it down
gently. The module should lock itself into place, and will not fall off if you flip the SBC upside
down. If not, try again.
Pin 2
