Operation Manual 5280 EPSHP
49
8.1.2.13. Tighten the adjustment screws 5 (fig. 33) as far as they will go, so that the blade of
the knife is cut into the base bar, approx. 0.3 mm.
WARNING!
Performing too deep cuts may result in shortened blade life!.
8.1.2.14. Tighten the fixing screws 4 (figure 33)
8.1.2.15. Switch on the power supply of the electrical system by turning the main switch knob
3 (fig. 33) to position "I".
8.1.2.16. Turn off the "knife change" function on the programmer 1 (fig.33)
8.1.2.17. Press simultaneously the push buttons 2. The knife will return to its upper position.
8.1.2.18. Turn off the power supply of the electrical system by turning the main switch knob 3
(fig. 33) to the "0" position
8.1.2.19. Firmly tighten the first screw on the left side of the knife. 2 (Fig. 31).
8.1.2.20. Turn on the power supply of the electrical system by turning the knob of the main
switch 3 (fig.33) to position "I"
8.1.2.21 Switch on the power supply to the control system by pressing the green push button
3 (fig.22).
8.1.2.22 Carry out a cutting test.
If the knife does not cut the pile to the last sheet, repeat steps 8.1.2.7.
8.1.2.23 Attach cover 2 with the screws 1 (fig.34)
Figure 34
