120
IO
SAVE THESE INSTRUCTIONS
Page 15
(120IO) SEQUOIA SPIRIT™ WOOD-GRAIN FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 08/08/2009
English
S
E
T
U
P
I
N
S
T
R
U
C
T
IO
N
S
POOL SETUP (continued)
3
. Next slide the vertical legs into the belt loop
located in the middle of the pool liner.
The bottom of the leg should be inside the white
restraining rope
(9)
located near the liner’s bottom
edge. Carefully slide the leg into the belt loop and place
the leg’s bottom inside the rope and then insert the
top of the leg into the bottom of the joint. Snap the leg
into the joint’s holes by aligning the holes and the
spring-loaded pin. Attach the leg’s end cap
(6)
to the
bottom of the leg
(see drawings 6.1 & 6.2)
.
4.
• Grab hold of the frame pool’s top beams in 2 – 3
locations. Shake the pool to be sure that all the joints,
legs and beams fit into each other. Ensure that all pins
are in position by pushing them downwards through
the holes
(see drawing 7.1)
.
• Pull gently, in an outward direction, at the bottom of
the leg; making sure the leg is inside the restraining
rope. The leg is to end up in an upright vertical
position and sitting in the middle of the patio block.
5.
See Krystal Clear™ filter pump manual, install the strainer nuts, flat strainer rubber
washers and threaded strainer connectors on the liner pre-cut holes. Use strainer valve
caps
(19)
and plug them into the threaded strainer connectors from the inside of the pool
so water will not run out while filling.
6
. • Before filling the pool with water, ensure that the drain plug inside the pool is closed and
that the drain cap on the outside is screwed on tightly. Fill the pool with no more than 1
inch of water. Check to see whether the water is level.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely
level. Setting up the pool on unlevel ground will cause the pool to tilt resulting in
the sidewall material bulging. If the pool is not completely level, you must drain the
pool, level the area or move the pool to a different area that is level, and re-fill the
pool.
• Smooth out the remaining wrinkles (from inside the pool) by pushing out where the pool
floor and pool sides meet. Or, (from outside pool) reach under the side of the pool ,
grasp the pool floor and pull it out. If the ground cloth is causing the wrinkles, have 2
adults pull from either side to remove all wrinkles.
7
. Fill the pool with water up to just below the
sleeve line.
(see drawing 7.2)
.
6.1
3
5
9
6
6.2
4
7.1
7.2
WATER LEVEL
