101
CD
SAVE THESE INSTRUCTIONS
Page 22
(101CD) MODEL 8110 KRYSTAL CLEAR™ DELUXE SALTWATER SYSTEM (SALT IN POOL) ENGLISH 7.5” X 10.5” PANTONE 295U 12/06/2007
MM
AA
IINN
TT
EE
NN
AA
NN
CC
EE
MAINTENANCE
IMPORTANT
Unplug power cord before cleaning and close plunger valves or insert
black hat-like plugs in strainer opening to prevent water spillage. Plug in
the power cord and open plunger valves or remove plugs when
maintenance tasks are completed.
Flow Sensor Cleaning
1.
In a counter-clockwise motion unscrew the collar of the flow sensor (7) and
remove it from the flow sensor conduit (6). See “Part Reference”.
2.
If deposits and debris are seen on the surface of the flow sensor, then use a
garden hose to wash it off.
3.
If flushing does not remove the deposits, use plastic brush (do not use a metal
brush) to clean the surface and the hinge if necessary.
4.
After the flow sensor has been inspected and cleaned, align the locator notch
on the flow sensor to the connection ridge in the conduit, turn the collar in a
clockwise motion tightening the sensor back into its position. Do not over
tighten.
Electrolytic Cell Cleaning
The electrolytic cell (4) has a self cleaning function incorporated into the electronic
control's programming. In most cases this self cleaning action will keep the cell
working at optimum efficiency. If the pool water is hard (high mineral content) the
cell may require periodic manual cleaning. Follow the cleaning instructions below.
To maintain maximum performance, it is recommended that you open and visually
inspect the electrolytic cell (4) every 3 months.
Connection Ridge
Locator Notch
Hinge
