![background image](http://html1.mh-extra.com/html/intex/krystal-clear-8110/krystal-clear-8110_owners-manual_2081401014.webp)
101
CD
SAVE THESE INSTRUCTIONS
Page 14
(101CD) MODEL 8110 KRYSTAL CLEAR™ DELUXE SALTWATER SYSTEM (SALT IN POOL) ENGLISH 7.5” X 10.5” PANTONE 295U 12/06/2007
SS
AA
LLTT
&&
PP
OO
OO
LL
WW
AA
TT
EE
RR
VV
OO
LLUU
MM
EE
SS
SALT & POOL WATER VOLUMES
Use only Sodium Chloride Salts
Use only sodium chloride (NaCl) salt that is at least 99.8% pure. It is also
acceptable to use water conditioning salt pellets (the compressed forms of
evaporated salt), but it will take longer time for them to dissolve. Do not use
iodized or yellow (yellow prussiate of soda) colored salt. Salt is added to the
pool water and the electrolytic cell uses this salt to create chlorine, the purer the
salt the better the performance of the electrolytic cell.
Optimum Salt Levels
The ideal salt level in the pool water is between 2500-3500 ppm (parts per million)
with 3000 ppm being optimal.
A too low salt level will reduce the efficiency of the Saltwater System and result in
low chlorine production. A high salt level may begin to generate a salty taste to your
pool water (this may occur at a salt level above 3500-4000 ppm). Too high of a salt
level may damage the power supply and cause corrosion to pool metal fixtures and
accessories. The following “salt table” shows the quantity of salt to use. The salt in
the pool is constantly recycled. Salt loss is due only to pool water physically
removed from the pool. Salt is not lost due to evaporation.
How to Add or Remove Salt
Adding Salt
1.
Depress the ON button on the filter pump switch to circulate pool water.
2.
Keep the Saltwater System “OFF”.
3.
Determine the amount of salt to be added (see “Salt Table”).
4.
Evenly spread the proper amount of salt around the inside perimeter of the
pool.
5.
To avoid clogging the filter, do not add salt through the skimmer.
6.
Brush the pool bottom to speed up the dissolving process. Do not allow salt to
pile up on the bottom of the pool. Run the filter pump 24 consecutive hours to
thoroughly dissolve the salt.
7.
After 24 hours and if all the salt is dissolved, turn on the Saltwater System and
set the saltwater pool system to desired operating time (see “Operating Time
Table”).
Removing Salt
If too much salt has been added, the unit will beep and display “code 92” (see
“Alarm Codes”). You need to lower the salt concentration. The only way to lower the
salt concentration is to partially drain the pool and refill with fresh water. Drain and
refill approximately 20% of the pool’s water until the “Code 92” disappears.
Pool Volume Calculation
Rectangular
Length x Width x Average Depth x 7.5
Length x Width x Average Depth
Circular
Length x Width x Average Depth x 5.9
Length x Width x Average Depth x 0.79
Oval
Length x Width x Average Depth x 6.0
Length x Width x Average Depth x 0.80
Types of Pool
Gallons
(pool size in feet)
Cubic Meters
(pool size in meters)