Intex Hydro Flow SM24101, Owner'S Manual, Page: 19 / 20

(303PO) MODEL SM24101 SWIMMING MACHINE ENGLISH 7.5” X 10.3” PANTONE 295U 02/21/2017
303
PO
SAVE THESE INSTRUCTIONS
English
Page 19
TROUBLESHOOTING GUIDE (continued)
PROBLEM CAUSE SOLUTION
Mounting bracket
can‘t be assembled
with the in ground
pool
●
The ground is not concrete, i.e., it is
asphalt, lawn or earth.
●
The screws are not fully inserted in the
drill holes.
●
Assembly the mounting bracket
on the cement ground.
●
Check and tighten the screws
securely.
swim-trainer unit is
not horizontal with
the water surface
●
The support bracket is not opened.
●
Adjust the support nuts on the
swim-trainer unit.
●
Open and adjust the support
bracket. See “Setup Instructions”.
●
Adjust the support nuts on the
swim-trainer unit.
No output from the
transformer ●
swim-trainer unit will hibernate if no
operating more than 1 hour.
●
The transformer fuse broken.
●
Motor too hot and overload protection is
shut off.
●
Turn off the transformer, waiting 2
minutes then turn on agin.
●
Replace the transformer fuse.
●
Let the motor cool down and
restart again.
No LED display
●
The transformer is unplugged or off.
●
The transformer is not connected with
swim-trainer unit.
●
Display panel cord is loose.
●
Display panel failure.
●
Emergency stop lanyard is put wrong
place.
●
Ensure the transformer is plugged
and switched on.
●
Connect the transformer with
swim-trainer unit.
●
Ensure that the display cord is
plugged fi rmly into the cell housing
receptacle.
●
Contact Intex Service Center.
●
Put the emergency stop lanyard
on correct place. See “Setup
Instructions”.
Abnormal display /
buttons not working
●
Display panel cord is loose.
●
Display panel failure.
●
Ensure the display cable is
plugged fi rmly into the display
panel receptacle.
●
Contact Intex Service Center.
Too noisy / Jet water
is weak or shaking
●
Swim-trainer unit is not fully immersed in
the water.
●
The motor impeller is broken.
●
swim-trainer unit components
not securely connected or in place.
●
Make sure the device is under
the water.
●
Turn off and replace the motor
impeller.
●
Check all components, especially
the support bracket. See “Setup
Instructions”.
Remote Control out
of control
●
The battery is on low power.
●
Replace the remote control
battery.
See “Operating Installations”.