Intex Hydro Flow SM24101, Owner'S Manual, Page: 18 / 20

(303PO) MODEL SM24101 SWIMMING MACHINE ENGLISH 7.5” X 10.3” PANTONE 295U 02/21/2017
303
PO
SAVE THESE INSTRUCTIONS
English
Page 18
TROUBLESHOOTING GUIDE
LED PANEL
CODE
PROBLEM SOLUTION
E
●
The maximum operating time
(90 minutes) has fi nished under the
same set mode.
●
It's normal. Turn off and unplug the unit.
Then plug the RCD/GFCI back and
restart all back again.
C
●
Low water level.
●
swim-trainer unit is not fully immersed
in the water.
●
Remote control is in an emergency cut
off situation.
●
Household voltage is too low.
●
Fill the pool with water up to correct water
level (see pool owner‘s manual).
●
Make sure the device is under the water.
●
It‘s normal. Turn off the transformer for 1
minute, then plug in.
●
Check the voltage is within the range
stated on the device housing.
H
●
Household voltage is too heigh
.
●
Clogged motor impeller
●
Check the voltage is within the range
stated on the device housing
●
Turn off the power, check and clean the
motor impeller
L
●
Water temperature is around
35°C (95°F)
●
Turn off and unplug the unit. When the
water has cooled down, plug the RCD/
GFCI back and restart all over again.
P
●
Operating time is too long
●
Water temperature is around
35°C (95°F)
●
Turn off and unplug the unit, after 30
minutes later plug the RCD/GFCI back
and restart all over again.
●
Turn off and unplug the unit. When the
water has cooled down, plug the RCD/
GFCI back and restart all over again.