. . . . .
S A F E T Y
Cautions
ATS-515, -525 & ATS-615 & -625 Interface & Applications Manual
1-5
Cautions
CAUTION
CAUTION
: Refer to Accompanying Documentation
Electrical Hazard
CAUTION
: High Voltage, Electrical Shock Hazard
Hot Surface
CAUTION
: Hot Surface
Cold Surface
CAUTION
: Cold Surface
CAUTION
1:
Observe the precautions given on the equipment and within this manual to
prevent damage to the equipment. Only use the equipment for the intended usages specified by
the manufacturer.
CAUTION
2:
Unauthorized personnel should not remove from the equipment those panels
which are provided for protection and/or cooling and/or require a tool to remove.
CAUTION
3:
Use proper handling and packaging procedures for static-sensitive circuit
boards. Assume that all circuit boards are the static-sensitive type.
CAUTION
4:
Before connecting the equipment to its electrical source, check that the ~ (ac)
voltage and frequency to be supplied to the system are correct for those listed on the system’s
data plate (located on the rear panel of the equipment).
CAUTION
5:
Disconnect the system’s power cord from its service supply before checking or
replacing any back-up batteries.
CAUTION
6:
Be very careful to avoid damaging the two thermocouples which go from the
Head thermal cutout board into the main air stream through various connector/supports. These
thermocouples are very delicate. Do not cut, twist, or bend them as internal connections can be
broken.
CAUTION
7:
When removing the flow control board, be extremely careful to avoid flexing
the board when disconnecting the inlet and outlet air hoses. Even a slight flexing of the board
can damage delicate components and/or wiring on the board.
CAUTION
8:
When making the system air connection to the System, hold the AIR INPUT
fitting with a second wrench while tightening the barb fitting to prevent the AIR INPUT fitting
from rotating in the panel.
