Weld-i
TM
HD 625
Instruction & Admin Manual
Page 14 of 47
InterTest, Inc. • 303 Route 94 • Columbia, NJ 07832
+1 (908) 496-8008 •
Released 8-20-21
General Operation
After power is applied to the control unit & turned ON, Right indicator LED will light
up on the front of the Camera CCU See Figure 2 & 3, wait 5 seconds, until the Main
Menu appears in the CCU Screen. Turn on the light source(s) as needed. White/UV
If faster response time is needed operate in 720p with Zoom On (crop mode) rather than
Off (scale mode). Scale mode still reads the whole sensor array thus running as if in
1080p.
Settings changes will be saved automatically on power down. Note, if any parameter is
changed a back step in menu is required for it to be saved on power down.
Change of settings is performed by moving through menu to desired function then
pressing the appropriate button for one step increments of value change or if the button
is held down rapid steps through multiple values will occur.
Operation & Menu Top Level Camera Imager Control Unit
Figure 8 HD CCU Menu Tree
