Page 13
Air Conditioner Controls (Continued)
TIMER: AUTO START/STOP FEATURE:
CHECK FILTER FEATURE:
DISPLAYS:
TIMER FUNCTION:
Press the Timer button to select "On or Off". After the
time is selected the unit will either turn on or off after
the timer has timed out.
Example:
If the unit is operating and "Off' is selected the unit will
turn off after the selected time times out.
If the unit is off and "On" is selected the unit will turn
on after the selected times out.
Press or hold the UP or DOWN button to change the
Auto time by 0.5 hour increments up to 10 hours, then
at 1 hour increments up to 24 hours. The control will
count down the time remaining until unit starts or
stops.
The selected time will update in 5 seconds. The
system will automatically revert back to display the
previous temperature setting or room temperature
when the unit is on. (When the unit is off, there is no
display.)
Turning the unit ON or OFF at any time or adjusting
the timer setting to 0.0 will cancel the Auto Start/Stop
timed program.
CHECK FILTER FEATURE:
This feature is a reminder to clean the Air Filter for more
efficient operation. The LED (light) will illuminate after 250
hours of operation. To reset after cleaning the filter, press
the Check Filter button and the light will turn off.
DISPLAY INDICATIONS:
Displays the following possibilities:
* °F or °C
* Timer setting
* Set temperature (all modes other than fan).
* Room temperature in the fan mode
* Error codes
Error codes:
1) AS
-
Room temperature sensor error. Unplug the
unit and plug it back in. If error repeats, call for
service.
2) LO
or
HI
– (Fan Only Mode) Room temperature
sensor error. Unplug the unit and plug it back in. If
error repeats, call for service.
3) “
·
” (see picture to the left)
-
Evaporator
temperature sensor error. Unplug the unit and plug
it back in. If error repeats, call for service.
4) HS
-
Electric heating sensor error. Unplug the unit
and plug it back in. If error repeats, call for service.
Press Timer
button
Press Check
Filter button
Display
