Page 12
Air Conditioner Controls (Continued)
TO SELECT THE OPERATING MODE:
TO USE THE ENERGY SAVER FEATURE:
SLEEP FEATURE:
Press the Mode
button
Press this button
Press Sleep
button
Select Operating Mode
：
To choose operating mode, press the Mode button.
Each time you press the button, a mode is selected
in a sequence that goes from Auto, Cool, Dry and
Fan. The indicator light beside the Mode button will
be illuminated.
To Operate Auto Feature:
When the "AUTO" function is selected, it will
automatically select the cooling, fan or heat (if
model has this feature). The temperature can be
changed as desired.
The air conditioner will control room temperature
automatically around the temperature set point.
In the "AUTO" mode, the fan speed is not
selectable. The fan will change speeds according to
the room temperature and the set point.
To Operate Fan Only:
Use this function only when cooling is not desired
such as for room air circulation or to exhaust stale
air. Open the outside vent for maximum circulation.
The outside vent should be closed for all other
modes (Cooling, Heating, Auto and Dry). Fan speed
is selectable (Auto, High, Med, and Low).
The Fan only function will display the actual room
temperature.
In other modes the set point is displayed.
If the Fan-Auto is selected, the temperature is
automatically set to 75
°F. The fan speed will
decrease as the room temperature approaches set
point.
To operate on Dry mode:
In this mode, the air conditioner will operate in the
form of a dehumidifier. Since the conditioned space
is a closed or sealed area, some degree of cooling
will continue.
ENERGY SAVER MODE:
This function is available in COOL mode. The fan will
continue to run for 3 minutes after the compressor shuts
off. The fan then cycles on for 2 minutes at 10 minute
intervals. If the room temperature goes above the set
point, the compressor turns on and begins cooling.
SLEEP MODE:
The temperature setting will increase by 2°F in 30
minutes. In another 30 minutes the temperature setting
will increase by another 2°F.
This temperature will be maintained for 6 hours and then
the temperature will return to the original set point
temperature.
To cancel the sleep mode, press the "Sleep" button.
