Intermec MobileLAN access, User Manual

Page: 20 / 34

Chapter 2 — Installing the Power Bridge
10 MobileLAN power User’s Guide
Cabling the Power Bridge
This section describes how to get the Power Bridge powered on,
connected to the network, and connected to the end device. Once
you get it connected, it is ready for operation.
The Power Bridge has no ON/OFF switch. To
connect or disconnect power to the Power Bridge,
simply insert or remove the power cable from the AC
power receptacle on the rear of the Power Bridge.
Attention: Le Pont d’alimentation n’est pas muni
d’un interrupteur Marche/Arrêt. Pour connecter ou
déconnecter l’alimentation du Pont d’alimentation,
veuillez tout simplement brancher ou retirer le câble
d’alimentation de la prise de courant alternatif située
à l’arrière du Pont d’alimentation.
To power on the Power Bridge
1 Insert a power cord into the power receptacle on the rear of the
Power Bridge.
2 Insert the other end of the power cord into the wall AC power
outlet. The Power Bridge powers up and runs through its Power
On Self Test (POST), which takes less than 10 seconds. During
the POST, the port is disabled and the LEDs light up in the
following sequence:
a The Main LED lights up.
b The Active LED light up.
c The Main LED and Active LED turn off.
d The Main LED lights up and remains lit.
e
The Active LED is ready for normal indications. For more
information, see the “Power Active LED Table” on page 5.