Intermec MobileLAN access, User Manual

Page: 19 / 34

Chapter 2 — Installing the Power Bridge
MobileLAN power User’s Guide 9
•
airflow is not restricted around the Power Bridge or through the
vents in the side of the Power Bridge. We recommend that you
provide a minimum of 25 mm (1 in) clearance around the two
sides and the back of the Power Bridge, excluding mounting
surfaces.
•
water or moisture cannot enter the case of the Power Bridge.
In addition, be sure that cabling is away from
•
sources of electrical noise such as radios, transmitters, and
broadband amplifiers.
•
power lines and fluorescent lighting fixtures.
Mounting the Power Bridge
Disconnect all cables from the Power Bridge before
continuing.
Attention: Déconnectez tous les câbles du Pont
d’alimentation avant de continuer.
There are two ways that you can mount the Power Bridge:
•
Free-stand mounting
•
Wall hanging
Free-Stand Mounting
•
Place the self-adhesive rubber feet provided in the kit on the
underside of the Power Bridge. Be sure to place the rubber feet
on their markings.
Wall Hanging
1
Drill two 6 mm (.24 in) holes.
2 Insert a screw (not included) in each hole, leaving 0.5 cm (.2 in)
of the screws protruding out of the wall.
3 Hang the Power Bridge on the screws.