Intermec MobileLAN access 2102 S, User Manual, Page: 19 / 68

Getting Started
1-9
1
4. Enter an unused IP address for the access point in the New IP Address for AP field.
5. Enter the MAC address of the access point in the AP Ethernet MAC Address field.
6. Click Set AP, and then turn on the access point. The status bar indicates the status
of the access point as it completes the configuration.
Note: You must complete Steps 3 through 6 before the access point has been
running for more than 60 seconds, or you will need to reboot the access point.
7. When the configuration process is complete, click Configure AP to launch a Web
browser to further configure the access point.
Resetting the 2102 S to Factory Defaults
This section explains how to reset the 2102 S to its factory defaults.
To reset the access point to factory defaults
1. Be sure the access point is not turned on, and then click Set Defaults.
2. Enter the current IP address of the access point in the Current IP Address of AP
field.
3. Click Set AP, and then turn on the access point. The status bar indicates the status
of the access point as it resets.
Note: You must complete Steps 2 and 3 before the access point has been running for
more than 60 seconds, or you will need to reboot the access point.
dsah