Intermec MaxiScan 2500, User Manual

Page: 18 / 30

INSTALLING THE SCANNER INTO A COUNTER SURFACE
This chapter describes the instructions and measures necessary for installing
the MaxiScan 2500 DP scanner.
Due to many POS systems on the market, a large number of communication
cables is available. Make sure that you have the right cable to connect the
scanner to your POS or computer.
Follow these steps carefully in order to install the scanner at an exact level with
the counter surface.
1. Locate the optimal scanner position in relation to the counter surface. Pay
attention to the product flow, the distance to the counter edge and
convenience for the operator.
2. You have two options for mounting the scanner into the counter. Either:
A) The scanner bottom is supported by a shelf
- Cut out a hole in the counter surface according to the measures
indicated in the illustration below.
- Fit a supporting shelf for the scanner following the instructions below.
14 Installing the MaxiScan 2500 DP
■
The scanner and the host system must be switched off before starting the
installation of the scanner. By following this precaution you prevent any
electrical damage.
■
You are advised to install the scanner in an air circulated place out of direct
sunlight.
NOTES
221.0
2
9
0
.0
1
0
8
.0
Scant9802_dl1_lp.qxd 03-11-2000 11:07 Pagina 14