Uninterruptible Power Supply Instructions
17
Removing/Replacing the Battery
Should the battery need replacement or if it needs to be removed,
this should only be done by trained personnel or those familiar
with fork-lift service and maintenance. A replacement battery can
be obtained from Intermec by ordering P/N 203-705-001.
Only qualified personnel may remove or replace the battery from
the UPS.
To remove the battery
1
Disconnect the cables from the UPS.
2
Remove the six screws from the battery access cover.
3
Remove the cover. Grasp the pull tabs firmly and pull to
remove battery.
4
Lift up the battery and remove the battery cable end clip.
To install a new battery or to reconnect the original one
1
Connect the battery cable end clip to the battery.
2
Place battery in UPS, making sure the pull straps are properly
positioned across the top of the battery.
3
Press firmly to fully seat the battery.
4
Replace the cover, making sure the pull straps remain
correctly positioned across the top of the battery.
5
Secure the cover with the six screws removed earlier.
6
Reconnect the cables to the UPS.
