4
Mini-Wave PE4 Installation Guide
Copyright © 2006 Intermatic, Inc.
Operating Programmed Functions
Depending on how you have wired the system, the five function buttons on the Hand-Held
Remote control the five circuits in the Control Center. You should apply the appropriate label to
the five buttons — describing the appropriate equipment according to your installation — from
the assortment of labels supplied.
Buttons
<1>
and
<2>
control
Relay 1
and
Relay 2
.
Buttons
<4>
and
<5>
control
Relay 4
and
Relay 5
.
Button
<3>
controls the Valve Actuators operating the booster pump, a water feature, or
whatever else you might have installed..
Button
<P/S>
controls the Valve Actuators.
When you press any of these buttons, the appropriate circuit toggles ON or OFF. In addition,
when the circuit is ON, the Hand-Held Controller’s display shows the circuit number along the
top of the screen.
Changing Batteries
The Hand-Held Remote Transceiver requires three (3) AA
batteries. Battery life is about one year in typical use.
To change batteries:
Use a small Phillips screwdriver to remove the three screws
on the back of the unit, as indicated.
Place three new batteries in the unit, making sure to
observe “
+
” and “
–
” polarity.
•
•
•
•
1.
2.
Remove
3 screws
Remove
3 screws
