0
Mini-Wave PE4 Installation Guide
Copyright © 2006 Intermatic, Inc.
Connection for Sta-Rite Heaters
Turn off power to heater at the
main circuit breaker panel.
Unbolt and remove the upper
jacket halves (Refer to heater
owners manual).
Open control box cover. (See
Figure 3-18.)
Remove the factory-installed
jumper between the Fireman’s
Switch terminals. (See Figure 3-19.)
Connect two #14 gauge
wires, designed for use in hot
environments, to the two brown
wires, marked heater connection,
on the panel-mounted receiver in
the Mini-Wave Control Center and
attach the other end to the two
spade terminals at the heater. You
can also cut the yellow jumper
wire and wire connect the black
wires to each yellow wire. (See
Figure 3-20.)
Route the wires out through the
knockout on the bottom of the
Control Box.
Do not disconnect high limit or
pressure switches.
Turn the heater on and maximize the temperature setting.
1.
2.
3.
4.
5.
6.
7.
8.
Replace jumper with leads to 24V Fireman’
s
Switch (field installed)
Replace jumper with leads to 24V Fireman’
s
Switch (field installed)
Time Clock or Remote
(purchase separately –
supplies power to
circulator pump)
Fireman’s Switch
completes the heater
24 Volt AC control
board circuit.
DO NOT connect this
circuit to Line Voltage!
Time Clock or Remote
(purchase separately –
supplies power to
circulator pump)
Fireman’s Switch
completes the heater
24 Volt AC control
board circuit.
DO NOT connect this
circuit to Line Voltage!
Figure 3-18
Figure 3-19
Figure 3-18
Figure 3-19
Figure 3-20
Figure 3-20
