![background image](http://html.mh-extra.com/html/interlogix/simon-3/simon-3_user-manual_2077296008.webp)
6
Numeric Pager
You may program your security system to send a numeric
message indicating system activities to your pager. The
system will send the message twice. See “Programming
Instructions”.
Use the following table to determine what the numeric
message is reporting.
Canceling and Preventing
Accidental Alarms
One of the biggest concerns you might have regarding
your security system, is causing an accidental alarm. Most
accidental alarms occur when leaving the residence after
arming the system, or, before disarming the system upon
your return.
Canceling Accidental Alarms
You may have up to 254 seconds (programmable by your
installer) to cancel an accidental alarm. See your installer
to find out what time is programmed. If the programmed
time has passed, you must call the central monitoring sta-
tion to cancel the alarm.
You have ___ seconds to cancel an accidental alarm.
To cancel an accidental alarm, simply enter your master
access code.
Guidelines for Preventing Accidental
Alarms
The following guidelines will go a long way toward pre-
venting accidental alarms.
❑
Close doors and widows before you leave your house.
❑
Gather your belongings, so you can exit immediately
after arming the system.
❑
Always enter and exit within the programmed delay
times.
❑
Make sure you leave through a door that has a delay
time set for it.
❑
Disarm your system immediately upon returning
home.
❑
Be aware of the devices in your security system and
learn how each one operates.
❑
If you have pets, ask your installer if you need pet
lenses in your motion detectors.
❑
Check the location of your smoke detectors. Smoke
detectors near bathrooms and kitchens can be tripped
by steam and smoke from cooking.
❑
Take note of system beeps, voice announcements and
indicator lights which indicate the current system sta-
tus.
How to Use an Off-Site Phone
You may use an off-site phone to arm/disarm your panel,
turn lights on and off, check system status, or conduct an
audio session (ask your installer if you have this feature).
How to gain access to the Control Panel:
1.
Call the panel and let the phone ring twice then hang
up.
2.
Wait at least 10 seconds and call the panel again. You
may wait up to 40 seconds before calling again.
3.
The panel should answer on the first ring. You won’t
hear any prompt when the system answers.
4.
Press the * button on your telephone and you will hear
system activated.
At this point you may perform the actions listed in the fol-
lowing table of phone commands. CODE refers to the
master and access codes programmed into your system.
System
Status
System trouble or
Open Sensor
System in alarm
Chime
Doors
Door will cause
chime
_________________
Chime
Special
Motion
Motion will
cause chime
_________________
Time Lights
Time activated
lights on
_________________
Sensor
Lights
Sensor activated
lights on
_________________
Numeric Pager Reporting
Reports
Numeric
Message
Reports
Numeric
Message
Phone Test
-101 -101
Intrusion
-108 -108
AC Power
Restore
-102 -102
Fire
-109 -109
AC Power
Failure
-103 -103
Disarming
-110 -110
Latchkey
-104 -104
Arming
-111 -111
No Activity
-105 -105
Fail to
Disarm
-112 -112
Panic Code
-106 -106
Fail to
Arm
-113 -113
Emergency
-107 -107
Panel Indicator Lights
Button
When the
Button Light is
On
When the Button
Flashes
CODE = any access code
Summary of Contents for Simon 3
Page 19: ...17 ...