ATS125x/1260 Four-Door/Four-Lift DGP Programming Guide
29
Report when door closed and locked
XX, NO - Report door closed & locked
*-Change
Select if a door is to report closed and locked (lock command send and zone
status normal).
• Yes: Report when door is (not) closed and locked to printer and Titan (zone
switches status (not) normal and/or door (not) locked).
• No: No reporting unless an alarm occurs (depends on zone type).
Notes
• This is only a reporting function.
• There is no event specified in the control panel. This function can only be
used in conjunction with the next option!
Report open/unlocked as unlocked
XX, NO-Map Open/Unlocked to Unlocked
*-Change
Select if a door (not) closed and locked needs to be reported as unlocked.
• Yes: Report (not) closed and locked as an unlocked message to the printer
and Titan.
• No: No reporting of unlocking.
Note:
This is only a reporting function.
Report door open / close
XX, NO - Report Door Open/Close
*-Change
Select if opening or closing of the door needs to be reported.
• Yes: Send a report to the printer and to Titan when the zone assigned to the
door is closed (zone switched from active to normal).
• No: No reporting unless an alarm occurs (depends on zone type).
Note:
This is only a reporting function.
Report forced door
XX, NO - Report Forced Door
*-Change
Select if the opening of a door without a valid card, PIN or request to exit should
be reported.
• Yes: Report opening of the door without a valid card, PIN or request to exit to
printer and Titan.