P/N 466-5438 • REV A • ISS 16OCT18
5 / 7
14. Reconnect the ends of the wire to the power terminals as
identified in Figure 4, taking particular care to ensure the
marked/dashed wire attaches to the Positive lead and the
unmarked wire attaches to the Negative lead.
15. Feed any extra wire back into wall. Wires should not
protrude outside of the wire drop opening.
16. Reattach the touch screen to the mounting base. Angle
the top of the touch screen into the tab hooks on the top of
the mounting base and swing the bottom of the touch
screen into the lower part of the mounting base until you
hear an audible click.
17. Reconnect the spaded ends of the power supply wire to
the terminal to the terminals on the power supply.
Note:
The dashed line/writing side of the wire indicates
positive. Ensure consistency by wiring the + to + and – to
– as polarity must be observed or touchscreen will not
function.
Operation
Refer to
Simon 5” TouchScreen User Guide
for basic touch
screen operation information. Refer to the panel
documentation for complete Simon XT, XTi, XTi-5 and XTi-5
V2 programming and operation information.
Note:
Test system at least once per week.
Note:
Each control unit shall indicate that the system is intended to
be checked by a qualified technical at least every 3 years.
Setting the clock
You can set the touch screen clock by setting the clock on the
Simon XT, XTi, XTi-5, or XTi-5 V2 panels.
Battery Pack Replacement
We recommend that you replace the backup battery pack
every 3-5 years. Only the part 60-924-BAT4SIMONTS5 can be
used as a battery pack replacement.
1. Remove the touch screen from the mounting plate by
depressing the button on the bottom of the touch screen.
2. Remove the five screws from the back cover of the touch
screen and separate the back cover off the front cover.
3. Disconnect the battery from the battery connector and
remove the battery as showing in Figure 6. Replace the
battery pack.
Avoid touching the touch screen face while you are replacing
the batteries.
Figure 6: Battery
Note:
If AC power is lost and battery pack is not present or
depleted, the touch screen will not power up until AC power
is restored (even if a new battery pack is installed).
Reset Button
The Reset button is located on the bottom right side of the
touch screen mounting plate (see Figure 7). To power cycle
the touch screen, use a toothpick to depress the recessed
Reset button. Note the reset has no impact on the Simon panel
or the overall state of the alarm system. The button simply
resets the only the touch screen to the same state
Note:
Do not press the Reset button while in programming mode.
Figure 7: Reset
