Intergraph TDZ 2000, System Setup

Page: 35 / 98

23
When using the SCSI Configuration Utility, remember the following keyboard tips:
u
Press the up or down arrow keys to move about in the menus.
u
Press
ENTER
to confirm a menu selection.
u
Press
ESC
to cancel a selection.
u
Select Help to display a Help screen with instructions and details.
To change the synchronous data transfer rate:
1. Insert the SYSUTIL diskette in the floppy drive.
2. From the Start menu, click Shut Down. The Shut Down Windows dialog box displays.
3. Click Restart and then click OK. The system restarts and the MS-DOS 6.22 Startup
Menu displays.
4. Select SCSI Configuration Utility and press
ENTER
.
5. From the main menu, select the SCSI host adapter that you want to configure and press
ENTER
. Two SYMB53C875 SCSI host adapters, one for each channel, are listed. Port
EC00 is the external bus; port E800 is the internal bus.
6. From the Utilities menu, select Device Selections and press
ENTER
.
7. From the Device Selections menu, select the SCSI device that you want to configure and
press
ENTER
.
NOTE Only eight SCSI devices are listed at a time. Select Device Selections 8-15 to list the next
eight SCSI devices.
NOTE If the device that you want to configure is not listed, exit the menu, repeat step 5 and select
the other host adapter. Then, continue with step 6.
8. Select Sync Rate (Megabytes/sec) and press
ENTER
.
9. Select the appropriate rate (Off, 10, 20, or 40) and press
ENTER
, select Exit This Menu,
and then press
ENTER
.
10. From the Device Selections menu, select Exit This Menu and press
ENTER
.
11. From the Utilities menu, select Exit This Menu and press
ENTER
. The Save/Cancel
menu displays.
12. Select Save Changes and press
ENTER
.
13. Eject the diskette from the floppy drive and press any key to restart the system.