Intergraph InterServe 600 Series, System Reference Manual, Page: 51 / 104

41
To define ISA boards without a configuration file:
1. Shut down and power off the system.
2. Insert the SYSUTIL diskette into the floppy diskette slot of the combo drive; then restart the
system.
3. When the MS-DOS Startup menu displays, select option 1 to run the SCU.
4. From the SCU Main Menu, select Step 2, then press
F
6. The ISA Board Definition Menu displays
as shown in the following figure.
( ) Video Board
( ) Multifunction Board
( ) Mass Storage Device
Board Name:
Manufacturer:
Board Type:
[Save - F10] [Load - F9] [New - F2] [Delete - F4] [Quit - ES]
Memory Ports IRQ DMA
ISA Board Definition
( ) 16 Bit
( ) 8 Bit
( ) 8 or 16 Bit
Slot Type:
5. Enter the data specified in the manufacturer’s configuration instructions.
NOTE Use the
TAB
and arrow keys to move the cursor from field to field. Once inside the DMA, IRQ, and
Ports fields, press
ENTER
to display the sub-fields for entering the information.
6. Press
F
10 to save the data to the system.
7. Press
ENTER
to return to the ISA Board Definition Menu.
8. Press
ESC
to return to the SCU Main Menu.
9. Select Step 2. The Add and Remove Boards Menu displays.
10. Select the required slot number and press
INSERT
.
11. Select
INSERT
again to add the board. The ISA Board Database Menu displays.
12. Select the correct board name and press
ENTER
.
13. When the Slot Selection Menu displays, select the required slot and press
ENTER
.
14. Press
ESC
to return to the SCU Main Menu.
15. Select Step 4 to save the configuration.
16. Select Step 6 to exit the SCU.
17. Remove the diskette from the combo drive; then restart the system.