Intergraph InterServe 600 Series, System Reference Manual

Page: 41 / 104

31
8. Align the processor module with the sockets that previously held the P6 bus termination card and
carefully insert the module.
9. Press the processor module firmly into the sockets. Secure the module with screws supplied in the
kit.
10. Replace the PCI option boards and close the base unit.
Adding Memory
You can expand the system memory up to double the base memory. The memory upgrade kit from
Intergraph contains two SIMMs and a disposable antistatic wrist strap.
CAUTION System memory modules available from Intergraph have been certified for use with Intergraph
computers at extremes of temperature and system load to ensure reliable performance. System
memory modules available from other vendors may function improperly or unreliably in your Intergraph
computer.
To avoid damaging the SIMMs and voiding the warranty, take the following precautions.
u
Do not bend, twist, drop, or otherwise handle the SIMMs carelessly.
u
Do not expose the SIMMs to moisture or extreme temperatures.
u
Do not remove the SIMMs from the antistatic bag until installation.
The following table shows valid memory configurations. Each bank contains two sockets, and both
sockets must be populated. Memory density must be the same in all populated sockets. NP designates
not populated.
Supported
Memory
Bank 0 Bank 1 Bank 2 Bank 3
64 MB 2 x 32 MB NP NP NP
128 MB 2 x 64 MB NP NP NP
2 x 32 MB 2 x 32 MB NP NP
VRMs
Clips
CPUs (with
Heat Sinks)
Processor
Module