Intergraph ImageStation ZII and use, Installation And Use Manual

Page: 18 / 22

14
6 Installing and Customizing the Altek Driver
The Altek driver software controls the operation of the Altek digitizer. This section describes how to
install and customize the Altek driver software.
To install the Altek driver:
1. Start the TDZ workstation base unit and monitor, and log on to Windows NT.
2. Insert the diskette containing the Altek driver in the system’s floppy disk drive.
3. From the Windows NT Start menu, select Run.
4. Key in the path to the Install program on the diskette (typically a:\install.bat).
5. Select Continue to install the Wintab driver.
6. Set the device size to be 24-inch x 36-inch.
7. Select Continue to accept the settings.
8. Select Yes to confirm the installation, and then select OK after successful installation. The
following appears:
Intergraph hardware requires a tablet size of 34 inches by 22 inches.
The necessary changes will be made to the registry now.
9. Select OK to accept the changes.
10. Select OK and then restart the system.
11. Proceed with customizing the Altek driver.
To customize the Altek driver:
1. From the Start menu, select Programs/Altek/Wintab Control Panel.
2. Under Features/Cursor Type, select 16-button cursor; then select OK.
3. Under Customization, de-select the default button assignments. Set button 7 to left click. Set
button 8 to right click. Set all other buttons to none; then select OK.
NOTE Button 7 corresponds to the index finger of the right hand resting on the two-handed controller. The
buttons range from 1 on the far left (not counting the force sticks) to 10 on the far right.
If this is a first-time setup, activate the stereoscopic display and customize the screen tracking area as
described in previous sections of this document.