Intergraph ImageStation ZII and use, Installation And Use Manual

Page: 12 / 22

8
4 Completing the Installation
You can adjust the monitor and digitizer tables and the Cyborg chair to meet the needs of the
individual user. Refer to Chapter 7 “Adjusting System Ergonomics” in this document. Arrange the
furniture with the monitor table centered behind and over the digitizer table. Center the Cyborg chair
in front of the digitizer table.
CAUTION Do not use auxiliary power outlets or extension cords when connecting the power cords to an AC
power wall outlet.
To connect the remaining power cords:
1. Attach one end of the power cord to the monitor. Attach the other end to an AC power wall
outlet.
2. Attach one end of the power cord to the TDZ workstation. Attach the other end to an AC power
wall outlet.
3. Attach the power cord from the Altek digitizer controller to an AC power wall outlet.
4. Connect the interface PEM power cord to an AC power wall outlet.
To verify the installation:
1. Place the interface PEM power switch in the ON (|) position.
CAUTION After installation, the 3-position interface PEM power switch should always remain in the ON (|)
position.
2. Verify that the two-handed controller is on the active area of the digitizer table.
NOTE You should remove the two-handed controller from the digitizing surface when using the system’s
mouse. Otherwise, the cursor may snap back to the original location as defined by the two-handed
controller.
3. Verify the proper Altek digitizer controller connection to the workstation.
NOTE The system must be powered up with the two-handed controller on top of the active area (center) of
the digitizer table for proper operation.
4. Turn on power to the monitor.
5. Turn on power to the TDZ workstation base unit.
6. Verify that the green LED is lit on front of the interface PEM to ensure its power switch is in the
ON (|) position.
Maintain the Equipment
To maintain the equipment:
1. Each week, clean the bottom of the two-handed controller with a cloth or paper towel dampened
with a glass cleaning solution.
2. Periodically clean the table surface with a glass cleaning solution.
3. Clean the monitor screen as required with a glass cleaning solution.