22 Chapter 2 - Maintaining the System
7.
If the monitor display is distorted, ensure the software setup is correct
for the monitor type.
If the software setup is correct, use a similar type monitor (if available
and functioning properly) to determine if the workstation is defective.
Diagnostics
Diagnostic utilities (and instructions for using them) for checking the
graphics boards are available in the Intergraph Bulletin Board Service
(IBBS). Refer to the TDZ Deskside Online Reference, or the Preface to the
workstation Setup and Maintenance Guide, for instructions to access the
IBBS and obtain files.
Installing the GL Display Driver
This section describes installing the GL display driver, in case the driver
becomes corrupted or inadvertently removed from the workstation. First,
power on the system and log on to Windows NT. Then install the GL driver
as described below.
➤
To install the GL display driver:
1.
Open Display in the Control Panel. The Display Settings dialog
displays.
2.
Select Change Display Type. The Display Type dialog displays.
3.
Select Change. The Select Device dialog displays.
4.
Select Other. The Install from Disk dialog displays.
5.
Insert the diskette containing the GL display driver into the floppy
disk drive; then select OK.
6.
Select Install. When prompted, confirm the path to the directory in
which the driver will be installed.
Summary of Contents for GLZ6
