Intergraph GLZ6, Setup & Maintenance Manual

Page: 14 / 44

4 Chapter 1 - Setting Up
Connecting the Equipment
CAUTION
If the workstation is powered on, shut down and power off the
workstation before connecting the equipment. Leave the power cord
connected between workstation and the AC outlet or Uninterruptible
Power Source (UPS) to maintain ground.
Once you have selected a location and placed the equipment where you want
it, follow these instructions to connect the equipment. The following figure
shows all the ports for the cable connections stated in the following steps.
➤
To connect the equipment:
1. Install the footstands on the bottom of the graphics tower.
2. Connect the Adapter cable to the adapter ports on the graphics tower
and the workstation.
3. Connect the monitor cable (or cables, if dual-screen) to the monitor(s)
and the graphics tower Video port.
4. Connect the VGA Loopback cable to the graphics tower VGA
Loopback port and the workstation VGA Loopback port.
CAUTION
Do not confuse the monitor cable (supplied with the monitor) with the
VGA Loopback cable (supplied with the graphics tower).
5. Connect the power cord to the graphics tower and to a grounded AC
outlet or (UPS).
6. Connect the power cord (supplied with the monitor) to the monitor
and a grounded AC outlet.