Interflex Datensysteme GmbH
6/13
6.5.2 Fastening the Back Panel of the Housing Using an Appliance Case
Using a level, fasten the back panel of the housing by installing the 3 screws included in delivery in the
holes marked (1). If the cable is to be inserted from the bottom, use mounting hole (2) instead of the
bottom mounting hole (1).
Depending on how the appliance case is installed, you can additionally secure the back panel of the
housing by installing screws in the two horizontal (4) or vertical (5) holes.
For further steps, please refer to: Attaching the IF-800 Outdoor/IF-801 Terminal.
6 This is how the drain wire is wrapped around the
insulation.
8 The blue wire and the PE wire from the I/O controller board
are connected to terminal 8 on the terminal strip.
7 The blue wire is connected to the strain relief.
9 Terminal strip
