PCI-4302
Interface Corporation
-14-
3.3 Cabling
1. Make sure that your computer and GPIB devices are turned off.
“Off”
“Off”
2. Connect the
PCI-4302
in your computer and the devices with GPIB cables.
3. First, turn on the devices. Second, turn on your computer.
Before operating the GPIB, follow the notes below:
□
Make sure that every device connected to the GPIB is turned on before the
computer is turned on.
□
Minimize the possibility of EMI.
□
Use Interface cables, or other IEEE Std. 488.1 cables.
3.4 Driver Software Installation
Installation procedure differs depending on your operating system.
•
Windows XP
(Refer to page 14.)
•
Windows 2000
(Refer to page 15.)
•
Windows NT 4.0
(Refer to page 15.)
•
Windows Millennium Edition
(Refer to page 15.)
•
Windows 98
(Refer to page 16.)
•
Windows
95
(Refer to page 16.)
After the installation of the software is successfully completed, configure the driver software parameters. Refer
to “3.8 Configuring the Driver Software Parameters,” page 18.
3.4.1 Windows XP
The driver may only be installed by a member of the System Administrators group.
1. When you log on to Windows XP, the device driver wizard will start automatically.
2. The
Found New Hardware Wizard
dialog box will appear, click
Install from a list or specific location
[Advanced]
, and then click
Next
.
3. Insert the CD into your CD-ROM drive.
4. Click
Search for the best driver in these locations
, and select
Search removable media
[floppy, CD-ROM...]
. Then click
Next
.
5. Installation will start automatically.
6. Follow further instructions on your screen.
Make sure that there are no conflicts in setting up the computer resources, such as I/O addresses and interrupt
request levels.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
