6. LED Indicators
Indicators
Blinking Behaviour
Status
GSM
(RED)
0.6 second on/ 0.6 second off Not Ready or Searching GSM signal
0.1 second on / 3 seconds off Registered to GSM network successfully
GPS
(GREEN)
Extinguish
GPS off
1 second on / 1 seconds off
GPS not fixed
Solid on
GPS fixed
7. Programming The IT-123
Note:- All mobile phones accessing the IT123 must have Caller ID enabled.
Step 1:- Setup the Master Phone Number
.
This defines the phone number that will program the device and receive all confirmation messages.
SMS the following command to the phone number in the IT-123.
$WP+commtype=PIN,1,Master Phone
Where:-
PIN is the allocated pin of the device as defined on the front page of this manual.
Master Phone is the phone number of the phone you are using to send this sms.
Example:-
$WP+commtype=0000,1,0412345678
The IT-123 will send a return confirmation SMS to your master phone number as
follows:-
$OK:COMMTYPE=1,0412345678,,,,,0.0.0.0,0,0,0.0.0.0
Step 2:- Setup the IT-123 Time Zone.
This defines the time zone of the IT123. If you do not set this command, the IT-123 will report all
positions using GMT Time (London Time).
SMS the following command to the phone number in the IT-123.
$WP+SETTZ=PIN,+/-,hour, minute
Where:-
PIN is the allocated pin of the device as defined on the front page of this manual.
Example:-
$WP+SETTZ=0000,+,10,00
The IT-123 will send a return confirmation SMS to your master phone number as
follows:-
$OK:SETTZ=+,10,0
Times Zones for Australia.
Eastern Seaboard +,10,00 or +,11,00 for Daylight Savings Time
SA
+,09,30 or +,10,30 for Daylight Saving Time
WA
+,08,00 ot +,09,00 for Daylight Savings Time
