11
How do I connect a computer to configure the Access
Point?
To install and run KickStart and to use the browser-based AP Configurator,
you will need a computer connected to the Access Point. There are two ways
to connect this computer:
x
If the Access Point and computer are connected to the same hub or to
Ethernet connections on the same network segment, use standard RJ-
45 cables for the connections.
x
If the Access Point and computer are connected directly, not through a
hub or network, use a “crossover” or “crosswire” cable to connect them.
Setting the IP address of the Access Point
The most important step after connecting the hardware and powering up the
Access Point is to assign an IP address to the Access Point. This address
identifies the Access Point on the wired LAN to which it is connected. The
Access Point must be on the same subnet mask as the wired network.
There are three ways to configure the IP address using the KickStart utility.
This utility must be run on a wired workstation connected to the same
network segment as the Access Point.
Ways of
setting the
IP address
When to use
Automatic
If the wired LAN to which the Access Point is connected has
a DHCP server, an appropriate IP address will be assigned
to the Access Point. In this case, when you run KickStart and
scan for Access Points, the assigned IP address will be
displayed. Click Next in KickStart and Finish. This will start
your default web browser and display the AP Configurator
that will allow you to configure security and other advanced
options.
Auto IP
(APIPA)
If there is no DHCP server on the wired LAN, KickStart will
tentatively assign an IP address based on the IP address of
the computer on which KickStart is running. Consult your
network administrator to verify that the address assigned is
available and correct. Use KickStart to change this address if
necessary.
Manual
If there is no DHCP server on the wired LAN, and the IP
address assigned by KickStart is not available, use KickStart
to manually enter an IP address supplied by your network
administrator.
