Intel UltraBookIIi, User Manual

Page: 100 / 158

A–12 UltraBookIIi User Guide
If the UltraBookIIi is configured at the
factory to support a hard disk drive in the
front-most, right-side device bay, this hard
disk drive replaces the unit’s removable
battery module and you cannot use battery
power.
Of the two left-side device bays, the device
bay closest to the front of the workstation is
reserved for the system's primary boot device.
If you have only one hard disk, install it in
this slot.
You cannot install a hard disk drive in the
rear-most, left-side device bay if your
configuration supports the Creator 3D
graphics display option. A ventilation
faceplate covers the secondary device bay on
the left side of the workstation, allowing a
maximum of two hard disk drives.
External Floppy (Optional)
The UltraBookIIi supports an optional 3.5-inch 720 KB/
1.44 MB external floppy disk drive via a standard 15-pin
floppy drive connector. The external floppy drive
provides media ejection via a manual push button. It
does not provide software eject.
The floppy drive supports both 720 KB, Double-Sided,
Double-Density (DSDD) and 1.44 MB, Double-Sided,
High-Density (DSHD) diskettes.
The floppy drive connector is located beneath the
PCMCIA slot, as shown in Figure A-9. The external
floppy is powered by the unit through the standard 15-
pin floppy drive connector.