Intel SR2600URLX, Service Manual

Page: 42 / 228

22 Intel® Server System SR2600UR/SR2625UR Service Guide
Hard Disk Drive Carriers
The server system ships with five drive carriers for installing five SAS or Serial ATA
(SATA) hot-swap drives.
Note: SAS drives are only supported on the Intel
®
Server System SR2600URLX (active version).
The top leftmost drive bay can be converted to be used as a floppy bay. To use the bay for
a floppy drive, the AXXUSBFLOPPY accessory kit must be used.
For instructions on installing hard drives, see “Installing and Removing a Hot-swap Hard
Drive (Intel® Server System SR2600UR only)” on page 71 .
Note: Drives can consume up to 17 watts of power each. Drives must be specified to run at a
maximum ambient temperature of 45
°
C.
Note: The Intel
®
Server System SR2600UR does not support all SAS or Serial ATA (SATA) hard
drives. For a web link to a list of supported hard drives, see “Additional Information and
Software” on page 4 .
Slimline Optical Drive Carrier
The slimline optical drive carrier can be used with a single slimline optical drive or USB
floppy drive. One slimline carrier is included with your server system; the optical drive
must be purchased separately. You cannot install both an optical drive and a USB
floppy drive.
The drive in the optical drive carrier is NOT hot-swappable. The system power must be
turned off to insert or remove the slimline optical drive carrier. For instructions on
installing an optical drive or USB floppy, see “Installing or Removing a Slimline Optical
Drive or Internal USB Floppy (Intel® Server System SR2600UR only)” on page 77 .
To use one of the drives provided by Intel, use the following order codes:
•
Slimline DVD-ROM Drive: AXXSATADVDROM
•
Slimline DVD-RW Drive: AXXSATADVDRWROM
Note: The Intel
®
Server System SR2600UR does not support all slimline optical drives. For a
web link to a list of supported slimline optical drives, see “Additional Information and
Software” on page 4 . Intel provides accessory kits for these drives.
Flex Bay
The server system also provides a multi-purpose drive bay that can support either a tape
drive, sixth 3.5-inch hard drive or two fixed 2.5-inch hard drives. This bay is located next
to the control panel. To order the optional tape drive kit, sixth hard drive kit, or fixed 2.5-
inch hard drive kit, use the following order codes:
•
SATA/SCSI Tape Drive Mounting Kit: ASR2500SATAPE or ADRTAPEKIT
•
Sixth SAS/SATA Hard Disk Drive (HDD) Kit: ASR2500SIXDRV