Removing the Processor
To remove the processor, follow these instructions:
1.
Observe the safety and ESD precautions at the beginning of this book. See “
Safety
Information
.”
2.
Turn off all peripheral devices connected to the server. Turn off the server.
3.
Remove power from your system by unplugging the AC power cord.
4.
Remove the chassis cover. See your chassis documentation for instructions.
5.
Server Chassis SC5275-E only: Disconnect the processor fan cable.
6.
Fully loosen the four captive screws on the heat sink.
7.
Twist the heat sink to break the seal between the TIM and the processor.
CAUTION
Do not attempt to lift the heat sink from the processor without first twisting it
to break the seal between the TIM and the processor. Lifting the heat sink
without breaking the seal may damage the processor or the processor socket.
8.
Lift the heat sink from the processor.
9.
Lift the processor lever.
10.
Remove the processor.
11.
Reconnect or replace any internal components you needed to disconnect or remove.
12.
Replace the server’s cover. Reconnect any external components you needed to disconnect.
13.
Attach the AC power cord.
Installing a PCI Card
Peripherals and add-in cards are not included in your system and must be purchased separately.
The PCI slots support full-height add-in cards or low-profile PCI add-in cards. If a low profile card
is installed in the standard full-height riser card, it must be equipped with a standard full-height PCI
mounting bracket.
1.
Observe the safety and ESD precautions at the beginning of this book. See “
Safety
Information.”
2.
Turn off all peripheral devices connected to the server. Turn off the server.
3.
Remove power from your system by unplugging the AC power cord.
4.
Remove the chassis cover. See your chassis documentation for instructions.
5.
Remove the screw that attaches the PCI bracket shield to the rear of the chassis to remove the
shield. Retain the screw.
6.
Insert the PCI card into the PCI slot.
7.
Use the screw removed in step 1 to secure the PCI card to the chassis.
8.
Reconnect or replace any internal components you needed to disconnect or remove.
9.
Replace the server’s cover. Reconnect any external components you needed to disconnect.
10.
Attach the AC power cord.
Intel Server Board SE7320SP2 / SE7525GP2 User Guide
28
