Intel R2000LH2, Quick Installation User'S Manual

Page: 6 / 20

2
General Installation Process
The installation instructions in this section are for common components of Intel® Server System
R2000LH2/LT2 Product Family.
Minimum Hardware Requirements
• Memory Type:
Minimum of one 512MB DDR3 1066/1333 MHz UDIMM or one 1GB
DDR3 1066/1333 MHz RDIMM.
• Processor:
Intel
®
Xeon ® processor E5-4600 product family.
• Hard Disk Drives: SATA
For a complete list of compatible processors, heatsinks, and memory, see
http://www.intel.com/support .
To avoid integration difficulties and possible board damage, your system must
meet the following minimum requirements:
1
Preparing System
Observe normal ESD (Electrostatic Discharge)
procedures.
Place your Intel ® Server System on a flat anti-static
surface to perform the following integration procedures.
Observe ESD procedures before reaching inside to make
server board connections or install components.
CAUTION:
Unplug all
AC power cords
and remove all
power supply
modules before
lifting tilt bay.
Lift up the
tilt bay.
A
Bend and
slide out
the air duct.
B
Remove the air duct from
the chassis.
C
Optical
Devic
e
Assembly
A
B
B
C
5
Remove Air Duct
Optical
Devic
e
Assembly
B
B
A
3
Remove Top Cover
B
Remove three screws.
Slide cover back and lift upward.
A
B
A
B
A
4
Remove Add-in Card Riser Assembly
Pull up the release lever of the
riser assembly.
Grasp the riser assembly with
both hands and pull up to
remove from system.
CAUTION: Place the
riser assembly upside
down or sideways to
avoid damage to the riser card
connector.
A
B
A
B
2
Remove Power Supply Module
Push the green
latch to unlock the
power supply.
A
While pushing the
green latch, pull
the power supply
out of the system
by the handle.
B
Repeat step A and
B to remove the
second power
supply.
C
C