Intel R2000LH2, Quick Installation User'S Manual

Page: 10 / 20

6
General Installation Process
2.5" HDD
d3
Install Hard Drives ...continued
3.5" Hard Drive Carrier (For system with 3.5" hard drive bay only)
Remove the drive carrier
by pressing the
green
button and opening the
lever.
d4
E
F
d2
d3
Slide the carrier out.
C Remove the four
screws securing the
HDD interface bracket
and remove the HDD
interface bracket .
Install the HDD interface bracket
from top. Secure the bracket with
three screws as shown.
Slide the 2.5" HDD into the
bracket to align the screw holes
with the right and left rail.
Break off the tab on the
HDD interface bracket .
Install 2.5" Hard Drive as option:
Secure the hard disk drive using
the four screws for 2.5" HDD .
Install the hard disk drive using
the same four screws as shown.
Make sure the connector end of
the drive matches the backplane
connector.
With the lever open, insert the hard disk drive assembly into
the chassis.
Push in the lever to lock
it into place.
d1
Bottom
View
TOP BREAK OFF T
AB
BEFORE MOUTING
2.5´´ HARD DRIVE
d2
CAUTION:
If you don't install all drives, empty drive bays must be
occupied by carriers with plastic drive blank provided to maintain
proper system cooling.
d4
2.5" HDD
TOP
BREAK OFF T
AB
BEFORE MOUTING
2.5´´ HARD DRIVE
Optical
Device
Assembly
A
B
TOP
BREAK OFF T
AB
BEFORE MOUTING
2.5´´ HARD DRIVE
Optical
Device
Assembly
E
F
d1
D
A
B
3.5´´ HDD
D
TOP BREAK OFF T
AB
BEFORE MOUTING
2.5´´ HARD DRIVE
C
Hard Drive Numbering Diagram
Drive 0 Primary 4 x 3.5’’ hard drive bay as shown
0 1 2 3