1. Loosen the 4 thumbscrews from the switch cover. There are 3 screws on the top,
and 5 screws on the back. Lift the cover on a 45-degree angle, then pull to
remove.
Figure 23.
Switch Cover Thumbscrews (Top View)
2. Holding the module at approximately a 45-degree angle, slide the connector into
module slot. Make certain to line up the notch on the module and the connector
(see following figure).
Figure 24.
Installing the Q7 Module
3. Once the module is seated properly in the connector, secure screw to the chassis
using a regular screwdriver.
Intel
®
Omni-Path Fabric—Installation
Intel
®
Omni-Path Fabric Switches Hardware
Installation Guide
June 2019
44
Doc. No.: H76456, Rev.: 10.0
