Intel® Server Board M10JNP2SB User Guide
37
9.1
Installing the Server Board
The instructions in this section describe the process of installing the server board in a chassis. The process
described is for reference purposes only. Refer to the selected chassis documentation to determine if
additional tools or steps are required.
Required Tools and Supplies
•
Anti-static wrist strap and conductive foam pad (recommended)
•
Screwdriver
–
Refer to the selected chassis documentation to determine the specific head required
1.
Verify that all cables are clear of the area in which the server board will be installed.
2.
Remove the server board from its packaging.
3.
Carefully lower the server board into the chassis ensuring that the mounting holes are aligned with the
standoffs on the chassis.
4.
Using a screwdriver, secure the server board with eight screws.
System Integration Guidance
The server
board includes two power connectors labeled “PWR1” and “PWR2” that are required to be
connected to power for the server board to boot correctly. Select a power supply that includes power
harnesses for both connectors and the selected peripherals.
9.2
Server Board Removal
The instructions in this section describe the process for removing the server board from a chassis. The
process described is for reference purposes only. Refer to the selected chassis documentation to determine
if additional tools or steps are required.
Required Tools and Supplies
•
Anti-static wrist strap and conductive foam pad (recommended)
•
Screwdriver
–
Refer to the selected chassis documentation to determine the specific head required
1.
Power off the system and remove the power cord(s).
2.
Disconnect all externally attached cables.
3.
Open the system chassis.
4.
If present, remove any PCIe* add-in cards installed.
5.
Disconnect and clear from the server board area all cables attached to connectors on the server board.
6.
Remove the processor heat sink (see Section 9.5).
7.
Remove the processor (see Section 9.6).
8.
Remove all DIMMs (see Section 9.8).
9.
Using a screwdriver, remove the eight screws used to secure the server board to the chassis.
10.
Carefully lift the server board from the chassis and place it into an anti-static bag.
Summary of Contents for M10JNP2SB
Page 2: ... Blank page ...
Page 15: ...Intel Server Board M10JNP2SB User Guide 15 Figure 4 Component height restrictions ...
Page 16: ...Intel Server Board M10JNP2SB User Guide 16 Figure 5 Major components and connectors 1 of 2 ...
Page 17: ...Intel Server Board M10JNP2SB User Guide 17 Figure 6 Major components and connectors 2 of 2 ...
