Intel® Server Board M10JNP2SB User Guide
34
8.
Reset and Recovery Jumpers
The server board includes two jumper blocks which can be used to configure, protect, or recover specific
features of the server board. Figure 17 identifies the location of each jumper block on the server board. Pin 1
of each jumper block can be identified by the arrowhead (
▼
) silkscreened on the server board next to the
pin.
Figure 17. Board jumper identification
8.1
Clear CMOS Jumper Block
This jumper resets BIOS options, configured using the <F2> BIOS Setup Utility, back to their default factory
settings.
Note:
This jumper does not reset administrator or user passwords.
To use the BIOS default jumper, perform the following steps:
1.
Power off the system and unplug the power cord(s).
2.
Open the system chassis and access the
“
C
lear CMOS”
jumper block.
3.
M
ove the “Clear CMOS” jumper from pins
1-2 (normal operation) to pins 2-3 (reset BIOS options).
4.
Wait five seconds then move the jumper back to pins 1-2.
5.
Close the system chassis.
6.
Plug in the power cord(s), power on the system and press
<F2>
during POST to access the BIOS setup
utility to configure and save desired BIOS options.
Note:
The system time and date may need to be reset.
Summary of Contents for M10JNP2SB
Page 2: ... Blank page ...
Page 15: ...Intel Server Board M10JNP2SB User Guide 15 Figure 4 Component height restrictions ...
Page 16: ...Intel Server Board M10JNP2SB User Guide 16 Figure 5 Major components and connectors 1 of 2 ...
Page 17: ...Intel Server Board M10JNP2SB User Guide 17 Figure 6 Major components and connectors 2 of 2 ...
