Intel® Server Board M10JNP2SB User Guide
43
9.6
Removing the Processor
Required Tools and Supplies
•
Anti-static wrist strap and conductive foam pad (recommended)
4.
Unlatch the processor load plate (see Section 9.2 step 2).
5.
Lift open the load plate (see Section 9.2 step 3).
6.
Remove the processor by carefully lifting it out of the socket, taking care
not
to drop the processor as well
as not touching any pins inside the socket.
7.
If a replacement processor is not being installed, install the socket protection cap.
9.7
Memory (DIMM) Installation
Figure 29. DIMM installation
1.
Locate the DIMM slot for installation. Ensure that the DIMM ejection tabs at both ends of the DIMM slot
are pushed outward to the open position (see Letter A).
2.
Carefully unpack the DIMM, taking care to only handle the device by its outer edges.
3.
Align the notch at the bottom edge of the DIMM with the key in the DIMM slot (see Letter B).
4.
Insert the DIMM into the slot (see Letter C) pushing down on the DIMM, until the ejection tabs snap into
place (see Letter D). Ensure that the ejection tabs are firmly in place (see Letter E).
9.8
Memory (DIMM) Removal
Figure 30. DIMM removal
1.
Identify and locate the faulty DIMM. Ensure that the ejection tabs of adjacent DIMM slots are closed.
2.
Open the DIMM ejection tabs at both ends of the selected DIMM slot (see Letter A). The DIMM will slightly
lift up from the slot.
3.
Holding the DIMM by its edges, lift it away from the slot (see Letter B).
Summary of Contents for M10JNP2SB
Page 2: ... Blank page ...
Page 15: ...Intel Server Board M10JNP2SB User Guide 15 Figure 4 Component height restrictions ...
Page 16: ...Intel Server Board M10JNP2SB User Guide 16 Figure 5 Major components and connectors 1 of 2 ...
Page 17: ...Intel Server Board M10JNP2SB User Guide 17 Figure 6 Major components and connectors 2 of 2 ...
