C H A P T E R 3 Intel
®
Express 530T Switch Users Guide
24
Installing a New Device
After you’ve installed a new switch on your network, you can use Intel
Device View’s Device Install Wizard to configure it for management.
To install and configure a new switch for
management
1
Start Intel Device View. The Device Install Wizard appears. If it
doesn’t appear, click Install from the Device menu or double-click
the appropriate MAC address in the Device Tree under Unconfig-
ured Devices. (The MAC address is located on the rear of the
switch.)
2
On the Device Install Wizard - Start screen, click Next.
3
On the Device Install Wizard - MAC Address screen, click the MAC
address of the new switch and then click Next.
4
Follow the instructions in the wizard to assign an IP address and a
name to the switch (or stack of switches).
NOTE
The 530T sends BootP
requests for several minutes;
after that time, if no IP has
been entered, the switch stops
sending the request and
continues to boot.
In a stack of switches, only one
MAC address (the control
switch’s MAC address) is
discovered.
530-Chapter3.fm Page 24 Monday, September 11, 2000 4:15 PM
