8 Installing the Intel EtherExpress PRO 10+ ISA Ethernet Adapter
Microsoft Windows NT 4.0 Workstation
8 Installing the Intel EtherExpress PRO 10+ ISA Ethernet
Adapter
Microsoft Windows NT
4.0 Workstation
Connecting to a Novell
NetWare 4.11 Server
Requirements
•
HP Vectra with Windows NT 4.0 Workstation.
•
Intel EtherExpress PRO 10+ ISA Ethernet card and driver disk version
3.50.
•
Driver File: EPRO.SYS, version 3.66
•
Microsoft Windows NT 4.0 Workstation media.
•
Microsoft Windows NT 4.0 Service Pack 4 media.
•
Novell NetWare 4.11 Server system that supports IPX network protocol.
•
Novell IntranetWare Client for Windows NT v4.11b installation media.
Device Configuration
Procedure
1
With the HP Vectra turned off, install the Intel EtherExpress PRO 10+ ISA
adapter card into an ISA slot.
2
Connect network cable media to the PRO 10+ card.
3
Power on the machine and start in MS-DOS mode.
4
Insert the Intel driver disk, “EtherExpress Ethernet Drivers” and execute
“SOFTSET2.EXE”.
5
Select “CONFIGURE NIC” and verify the resource settings listed above
under the heading “Device Configuration”.
6
If changes are required, save those changes and exit.
7
Remove the Intel Software driver diskette and restart the system.
Device Configuration
Vectra Vli8
Vectra VEi7
Vectra VEi8
Interrupt
05
03
07
I/O Address
210
210
210
Summary of Contents for EtherExpress PRO 10+ ISA
Page 1: ...Intel EtherExpress PRO 10 ISA Ethernet Adapter Installation Guide ...
Page 34: ......
Page 35: ......
