6 Installing the Intel EtherExpress PRO 10+ ISA Ethernet Adapter
Microsoft Windows NT 4.0 Workstation
6 Installing the Intel EtherExpress PRO 10+ ISA Ethernet
Adapter
Microsoft Windows NT
4.0 Workstation
Connecting to a
Windows NT 4.0 Server
Requirements
•
HP Vectra with Windows NT 4.0 Workstation.
•
Intel EtherExpress PRO 10+ ISA Ethernet card and drivers disk version
3.50.
•
Driver File: EPRO.SYS, version 3.66
•
Microsoft Windows NT 4.0 Workstation media.
•
Microsoft Windows NT 4.0 Service Pack 4 media.
•
Microsoft Windows NT 4.0 Server system that supports NetBEUI, NWLink
IPX/SPX Compatible Transport, and NWLink NetBIOS network protocols.
Device Configuration
Procedure
1
With the HP Vectra turned off, install the Intel EtherExpress PRO 10+ ISA
adapter card into an ISA slot.
2
Connect network cable media to the PRO 10+ card.
3
Power on the machine and start in MS-DOS mode.
4
Insert the Intel drivers disk, “EtherExpress Ethernet Drivers” and
execute “SOFTSET2.EXE”.
5
Select “CONFIGURE NIC” and verify the resource settings listed above
under the heading “Device Configuration”.
6
If changes are required, save those changes and exit.
7
Remove the Intel Software driver diskette and restart the system.
Device Configuration
Vectra Vli8
Vectra VEi7
Vectra VEi8
Interrupt
05
03
07
I/O Address
210
210
210
Summary of Contents for EtherExpress PRO 10+ ISA
Page 1: ...Intel EtherExpress PRO 10 ISA Ethernet Adapter Installation Guide ...
Page 34: ......
Page 35: ......
