Turning On & Basic Operations
En-33
Using the Tuner
With the built-in tuner you can enjoy AM and FM radio
stations. You can store your favorite stations as presets for
quick selection.
You can also change the frequency steps (
➔
page 80
).
Note
•
(North American models)
When using the Whole House Mode
with “
TUNER
” input selector, connect antennas to both the
MAIN
and
ZONE 2 ANTENNA
jacks/terminals (
➔
pages 20
,
51
,
86
).
Tuning into Radio Stations
■
Auto tuning mode
■
Manual tuning mode
In manual tuning mode, FM stations will be in mono.
■
Tuning into stations by frequency
You can tune into AM and FM stations directly by entering
the appropriate frequency.
Presetting AM/FM Stations
You can store a combination of up to 40 of your favorite
AM/FM radio stations as presets.
Listening to AM/FM Radio
This section describes the procedure of using the
buttons on the front panel, unless otherwise specified.
1
Press
Tuner
to select either “AM” or “FM”.
In this example, FM has been selected.
Each time you press
Tuner
, the radio band changes
between AM and FM.
(Actual display depends on the country.)
Band
Frequency
1
Press
Tuning Mode
so that the AUTO indicator
lights on the AV receiver’s display.
2
Press
Tuning
q
/
w
.
Searching stops when a station is found.
When tuned into a station, the
TUNED
indicator
lights. When tuned into a stereo FM station, the
FM
STEREO
indicator lights as shown.
Tip
• Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
manual tuning mode and listen to the station in mono.
1
Press
Tuning Mode
so that the AUTO indicator
goes off on the AV receiver’s display.
2
Press and hold
Tuning
q
/
w
.
The frequency stops changing when you release the
button.
Press the buttons repeatedly to change the frequency
one step at a time.
TUNED
FM STEREO
AUTO
1
On the remote controller, press
Tuner
repeatedly
to select “AM” or “FM”, followed by
D.TUN
.
(Actual display depends on the country.)
2
Within 8 seconds, use the number buttons to enter
the frequency of the radio station.
For example, to tune to 87.5 (FM), press
8
,
7
,
5
or
8
,
7
,
5
,
0
.
If you have entered the wrong number, you can retry
after 8 seconds.
1
Tune into the AM/FM station that you want to store
as a preset.
See the previous section.
2
Press
Memory
.
The preset number flashes.
(Actual display depends on the country.)
3
While the preset number is flashing (about 8
seconds), use
Preset
e
/
r
to select a preset from 1
through 40.
To be continued
