Advanced Operations
En-74
Remote ID
■
Remote ID
`
1
,
2
, or
3
When several Integra/Onkyo components are used in
the same room, their remote ID codes may overlap.
To differentiate the AV receiver from other
components, you can change its remote ID from “
1
”,
to “
2
” or “
3
”.
Note
• If you do change the AV receiver’s remote ID, be sure to
change the remote controller to the same ID (see below),
otherwise, you won’t be able to control it with the remote
controller.
Changing the remote controller’s ID
Remote Mode Setup
See “Looking up for Remote Control Codes”
(
With this preference, you can protect your settings by
locking the setup menus.
■
Setup
`
Locked
`
Unlocked
When “
Locked
” is selected, the setup menus will be
locked and you cannot change any setting.
8. Remote Controller Setup
1
While holding down Receiver, press and hold
down Q Setup until the remote indicator lights
(about 3 seconds).
2
Use the number buttons to enter ID 1, 2, or 3.
The remote indicator flashes twice.
9. Lock Setup
Summary of Contents for DTR-40.5
Page 1: ...AV Receiver DTR 40 5 Instruction Manual...
Page 102: ...Appendix En 102 Memo...
Page 103: ...Appendix En 103 Memo...
